Industrial LED Emergency Light 2x6W Double 2x6W IP65

Double LED Emergency Light

LED emergency light is used in all kinds of buildings, when it is turned off, the emergency light can light up automatically. It is mainly used in shopping malls, hotels, offices.

This emergency light complies with CE standard, uses high quality electronic components especially for 6V/4500mAH battery. The LED spotlight type features SMD 2835 LED chip with high lumen output, long lifetime and low power dissipation. The emergency light has charge and discharge protection function, which makes the battery reach the best service life. In addition, this emergency light has been tested in wet environment and can achieve IP65 rating.

The two LED spotlights of the emergency light can be swiveled up and down. It is essential in some places to have several emergency lights in case of power failure. Thanks to them we will be able to find an exit easily or some necessary service to face that unforeseen as it can be the location of a fire extinguisher or the distribution board, among others. We must always keep in mind that there are guidelines to follow, since the regulations are strict regarding the number of luminaires to be installed and their location, depending on the place may vary.

Features of LED emergency light

• Built-in battery: Ni-Cad 6V/4500mAH.
• Voltage: 220-240V
• Frequency: 50/60HZ.
• Power: 2x6W.
• Battery life: 180 minutes.
• Intensity: 600 lumens.
• IP65
• Measures: 238mm*320mm*130mm.

Applications

• Parking lots and storage rooms
• Premises and workshops
• Stores and department stores
• Emergency exits
• Warehouses
• Offices
• Emergency stairs

Instructions for use

1. The emergency luminaire can be installed outdoors in a damp environment.
2. It must be a single circuit line. The common return should not be shared with other lights or any electrical appliance with switch, which ensures that the emergency light can be charged normally.
3. Please change the battery when the emergency time is less than the rated time. Method: Cut off the power, take out the products. Then open the top cover, unplug the connection line between the battery and the circuit board, remove the battery, fix the new battery in the original place and put the plug of the battery connector on the circuit board. After finishing these steps, please close the cover, put the product in the original place and plug it in.
4. Check and confirm that the product works normally.
5. The installation size is suitable for the position of the mounting hole on the back of the product.