LED emergency light for surface or recessed mounting 120lm 3W 3 hours IP20

Surface or recessed LED emergency light 120lm 3W 3 hours IP20

LED surface emergency light 150lm 2,5W - 3 hours IP20

Name: Surface downlight LED emergency luminaire 150 lumens 3 hours
Brand: Barcelona LED
SKU: B1056
Price: 19.95 EUR
Availability: InStock

SKU:B1056

€19.95 Tax included

In stock 424 units

Data sheet

The 2.5W surface mounted LED emergency light is IP20 rated, so it is intended for indoor use.

It can be installed both on ceilings and walls, and its uses are varied, and can be used both in the home and in any commercial premises, offices, hotels, etc..

It includes a Ni-mH battery of 3.6V and O.6Ah and has an autonomy of 3 hours.

Its LED technology allows great energy savings and excellent performance.

Shipping to Africa available

public

For any shipping requests to Africa, please contact our sales department at: comercial@barcelonaled.com

Surface mounted emergency light with 150 lumens and 3h autonomy.

The surface mounted LED emergency light includes a red pilot light with "CHARGE" indicator. If the red light is on, it indicates that the lamp is charging and the power supply is flowing properly. When a power failure occurs, the red light turns off, and the lamp will light up.

In accordance with current regulations, it incorporates a "TEST" button on the front of the lamp. The lamp activation occurs instantaneously after the interruption of the power supply, without flickering and without heating.

Technical characteristics:

✔ Integrated battery: Ni-mH, 3.6V, O.6Ah.
✔ Voltage: 230V/AC
✔ Approx. battery life: 3 hours on full charge.
✔ Luminous flux: 150 lumens.
✔ IP20

Instructions for use:

✔ Before installation, disconnect the power supply.
✔ Do not install this product in an environment of exterior doors, humidity and corrosive gases.
✔ Use only one circuit, do not connect with other lights, to ensure normal emergency recharging.
✔ Check regularly for proper operating conditions.
✔ When long-term storage or out of service, check the light condition every three months to maintain battery performance.

Installation:

The installation method of the emergency light is as follows:

✔ Open the product (turn the bottom).
✔ Use the fixing screw to fasten the bottom housing on the wall.
✔ Pass the AC cable through the hole in the lower housing and connect the main circuit board to the L and N terminals.
✔ Close the diffuser.
✔ Connect to the AC power supply.