LED Strip 12V-DC 30W 6mm Zig Zag IP20 (SMD2835 60ch/m) 5 meter roll

Zig Zag LED Strip 12V for contours, ultra-flexible

• 5 meter reel

• 60 chips/meter SMD2835

• Cutting distance 50mm

• IP20 protection degree

• PCB width: 6mm in zig zag pattern

• 3M self-adhesive

• Flexible, high brightness and luminosity

• Requires power supply (not included)

The LED strip is an element that integrates into your projects with minimal visual impact, creating indirect and diffused lighting that highlights architectural elements.

SMD2835 LED strips are low power and low consumption. They can be cut every 3 chips, allowing them to be adapted and spliced according to the needs of each project.

Installation:

The LED strip comes supplied with 3M self-adhesive tape on the back. Place it on a smooth, non-porous surface and make sure to clean it beforehand. As a flexible strip, it can be used in tight bends. Mounting against the power supply can be done using connectors or by soldering the cable directly to the power supply.

For a complete LED strip installation you will need a controller, a power supply and, optionally, aluminum profiles (surface or recessed). It is estimated that for 12V LED strips, if you want to make stretches longer than 5 meters, you will need to install additional power supplies and signal amplifiers, to avoid voltage drops.

Recommended uses:

• Highlighting architectural contours.

• Lighting under furniture and shelves, showcases, showcases

• Aisles, shop windows, with indirect illumination

Applications for ZIGZAG LED Strip:

- Signs

- Contours of pictures, masks or objects.

- Railings

- Shelves

- Showcases

Technical Installation:

1. The installation surface must be smooth, clean and dry.

2. The LED component part can not be fixed on the surface of a sharp edge.

3. The contour LED strip must not be knocked or stepped on.

4. The LED strip can be cut along the marked cutting lines.