OSRAM T8 Crystal LED Tube 150cm 20W | SubstiTUBE STAR

LED Tube T8 20W 150cm glass tube

Replaces conventional 1500mm fluorescent tubes.

High and homogeneous brightnessLED T8 tubes, with glass and plastic coating with high light transmission (more than 90%). Uniform light distribution. Instant on, allowing you to use 100% of the light emitted as soon as you press the switch, with no warm-up time. Energy class A+. Compatible with T8/G13 socket.

Lifetime of up to 30,000 hours and 200,000 switching cycles. Dimensions of 1500x267x267mm and a weight of only 230 grams.

High luminous efficiency of 110lm/W and optimum color rendering index, CRI>80. Power factor >0.9.

Suitable for mono and duo operation with conventional power supply. Perfect for installation as lighting in garages, warehouses, staircases, corridors, etc.

Color temperature to choose between:

• Neutral light, 4000ºK, ideal for highlighting and illuminating the whole area without disturbing the view.
• Cold white light, 6500ºK, perfect to improve concentration and optimize visual performance in kitchens, bathrooms and offices.

Features LED tube 150cm

• Short circuit and overheating protection.
• Wide opening angle of 330 degrees.
• Glare-free opal coating.
• Wide AC input range from 175V to 265V.
• Tube diameter: 25.8mm.
• Base diameter: 26.7mm.
• Total length: 1513mm.
• Socket: G13.
• Luminous flux: 2200 lumens.
• Luminous efficiency: 110lm/W.
• Degree of protection IP20.

T8 LED tube applications

• Direct replacement of conventional fluorescent 150cm, general lighting.
• Perfect for illuminating closed parking lots, offices, stores, commercial galleries, kitchens, etc.
• Thanks to its angle, it is ideal for placement on walls.

Installation of Ferromagnetic ballasts

Step 1: Turn off the main switchboard and check that there is no electric current.

Step 2: Take out the old tube and then the starter.

Step 3: Put the new LED starter bridge.

Step 4: Remove the capacitor or capacitor (to avoid overvoltage).

Step 5: Install the new LED tube.

Installation on Electronic ballasts

Step 1: Turn off the light at the main switchboard and check that no power is coming through.

Step 2: Remove the old tube (in this case there is no starter, as it is incorporated inside the electronic ballast).

Step 3: Disconnect the cables that enter the electronic ballast (no need to remove it, just disconnect it electrically).

Step 4: Choose one of the 2 tube holders to connect its 2 wires directly to the mains.

Step 5: We recommend to mark the lamp holder where the connection has been made to facilitate the installation of the LED tubes.