Infrared motion sensor PIR orientable IP44

The most important features of this sensor, is that it is able to detect light at night and day with a built-in dimmer, allowing significant energy savings and using the energy of the luminaires in a more effective way. In addition, it has a waterproof rating of IP44, so it can be installed both indoors and outdoors.

Thanks to this, the sensor will detect the presence of people and turn on the lights automatically. Once it detects that there is no one in range, it will turn off the lights.

Motion sensor to save on the electricity bill, both for domestic and industrial use. This infrared detector is designed to be oriented, thus improving its effectiveness. Designed for indoor application.

High efficiency orientable motion detector

Thanks to the predefined and adjustable time between 10 seconds and 7 minutes, the detector will turn off at the desired time. The switch-off time and the sensitivity of the device can be adjusted according to the ambient light (range from <10 to 2000 LUX). If the "LUX" value is adjusted to the "SUN" symbol, it will work during the day and night.

This surface-mounted PIR infrared motion sensor can be easily oriented to get the most out of the product. In this way the detection range can be adjusted as much as possible to the desired needs.

Sensor 180 ° working range, range up to 12m, protection class IP44 (protection against splash water).

Detects day and night automatically. You can adjust the ambient light sensor to your liking: Set to the SOL value to operate during the day and night. Set to minimum LUX value to work in night condition (less than 3lux ambient). For other light conditions try different settings. The timer function adds a time delay for switching on and off. You can orient this motion detector in a way that improves its effectiveness.

• ✔ Voltage: 220 -240V/AC
• ✔ Frequency: 50Hz
• ✔ Light sensor: 10 to -2000 LUX(adjustable).
• ✔ Timer: min: 10sec±3sec. max: 7min±2min.
• ✔ Rated capacity: 2000W (incandescent bulb).
• ✔1000W (saving bulb).
• ✔Sensing distance: 12m max(<24°C).
• ✔Sensor angle: 180"
• ✔Working temperature:-20-+40ºC.
• ✔Supported humidity:<93%RH
• ✔Recommended height:1.8m - 2.5m
• Power consumption: 0.9W (running) 0.9W (stopped)
• ✔Sensing speed: 0.6-1 .5m/s

Installation outdoor or indoor surface sensor.

• Loosen the screw at the bottom.
• Pass the power cable through the hole with gasket at the bottom. Connect the power cable according to the wiring diagram.
• Fix the sensor to the wall with the screw.
• Tighten the screw at the bottom.

Compatible with most LED luminaires and can be set to work only at night or all the time to suit the needs of each room. Detection angle of 180 degrees.

Avoid pointing the detector towards highly reflective objects such as mirrors, or near heat sources.